*Room or Location

Type in the room or location where this window covering will be installed. This information will be included on the label of the box the window covering is shipped in for easy dispersal.

Measurement

*Width

Measure the width

Measure the width side-to-side of the exact window frame opening in three places (top, middle, bottom). Please provide the smallest of these three measurements and round down to nearest 1/8 inch.

Please note that for an inside mount blind, Blind Ambitions recommends a standard deduction of 3/8” (0.375”) on the dimension of the window. This standard deduction permits the blind and the brackets to be installed in the window.

Obstructions may cause measurements to vary. Make sure to note them when measuring.

Important: Measure the depth of any protruding sill, ledge or molding that may interfere with the hanging of your blind. Protruding heaters, frames, locks, handles, sills etc. may interfere with your measurements. Please indicate them when measuring your window frame.

Remember: To ensure accurate measurements, use only a high quality, steel tape measure with a wide blade (minimum 1/2”). Tell your Sales Associate about any obstructions inside your window frame (locks, screens, doorknobs, handles, radiators, plants, etc.). Provide all measurements to the nearest 1/8”.

Required minimum depth: Min depth needed: 1 1/2", Full recess depth: 3 1/4”

*Width Fraction

-- Please Select --0/0 1/8 1/4 3/8 1/2 5/8 3/4 7/8

*Height

Measure the height

For inside mount: Measure the HEIGHT (top-to-bottom) of the exact window frame opening in three places (left, center, right). Please provide the LARGEST of these three measurements.

For outside mount: Measure from frame to frame. we recommend to add 2" to the height for wall installation.

 

Obstructions may cause measurements to vary. Make sure to note them when measuring.

Important: Measure the depth of any protruding sill, ledge or molding that may interfere with the hanging of your blind. Protruding heaters, frames, locks, handles, sills etc. may interfere with your measurements. Please indicate them when measuring your window frame.

Remember: To ensure accurate measurements, use only a high quality, steel tape measure with a wide blade (minimum 1/2”). Tell your Sales Associate about any obstructions inside your window frame (locks, screens, doorknobs, handles, radiators, plants, etc.). Provide all measurements to the nearest 1/8”.

Required minimum depth: min depth needed is 1 1/2" and for full recess you need 3 1/4”

*Height Fraction

Measure to the nearest 1/8" of an inch, if the size is on a 1/16" mark, then round down to the next 1/8"

-- Please Select --0/0 1/8 1/4 3/8 1/2 5/8 3/4 7/8

*Color

-- Please Select --White + White Off White Bone White + Creme White + Beige White + Grey Bronze Black + Bronze Black + Black

*Openness Factor

Come as 3%, 5% or 10% openness factor. The higher the openness factor the more light that filters through the shade.

• 10% Open
• 5% Open
• 3% Open +12%

*Mount Location

• Inside Mount
• Outside Mount

*Lift Control

• Beaded Chain
• Motorized +$350.00

*Control Side

• Right
• Left

*Fabric Roll Direction

• Roll Under the Top Roll (Typical)
• Roll Over the Top Roll (Reverse)

*Valance

• No Valance
• 3" Square +$50.00
• 3" Round with Fabric Insert +$100.00

*Bottom Rail

• Heat Sealed Hem Bar

*Add Install

Select yes if you would like this blind installed. Minimum charge for install is $100.

• Yes +$35.00
• No

Add any additional comments

Maximum number of characters: 300

* Required Fields